Shopped with us before?

Do not put fingers into product vent. KEEP OUT OF REACH OF CHILDREN AND PETS.INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONSIMPORTANT SAFETY INSTRUCTIONS PLEASE SAVEWARNING: When using electric products, basic safety precautions should always be followed: Read all instructions before using. To reduce risk of injury, keep out of reach of children and pets. Product not a toy. Intended for adult use only. Do not put fingers into product vent to avoid injury.RISK OF ELECTRICAL SHOCK AND FIRE HAZARD. Use only in properly functioning 120-volt electrical outlet. If used in a GFCI outlet, it is recommended to test the outlet when the refill is replaced. For indoor use only. Do not use with extension cords. Do not immerse in water or use in damp/wet areas. Do not use around open flame. Keep warmers and refills away from furniture, fabrics, bedding and other materials, which might present a fire hazard. Do not use in small confined pet areas without adequate ventilation. Do not obstruct or block airflow from unit. Use only in areas with at least 30cm/12" clearance above the unit to avoid potential discoloration of surrounding surfaces.FCC Compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.CAUTION: EYE IRRITANT. Avoid contact with eyes and skin. Do not put fingers into product vent. Wash hands after handling. KEEP OUT OF REACH OF CHILDREN AND PETS. FIRST AID TREATMENT: Contains fragrance oils. IF SWALLOWED, call a poison control center or physician immediately. Do not induce vomiting. If in eyes, rinse with plenty of water for 20 minutes. If eye irritation persists, consult a physician.

1. Remove the base of the device and insert a Febreze Plug refill into the top until you hear a click. 2. Re-attach base to the device by lining up the edges and lightly pushing together. 3. Plug-in the device, a light will blink twice on the top of the device to indicate that it is ready to use. 4. Adjust the warmer to the desired setting (off, low, med, high) using the slider on the back. 5. When the light on the top of the device starts blinking, it may be time to change your Febreze Plug refill. See insert for additional safety information.CLEANING INSTRUCTIONS: Fragrance oils may collect on the warmer over time. To clean, unplug the external power supply from the outlet and wipe with clean, dry cloth. USER MAINTENANCE: There are no user maintenance parts, do not open anything in the top part of the warmer.INSTALLATION INSTRUCTIONS1) Unscrew both caps on fragrance refill and discard.2) Remove the base of the warmer by lightly pulling until separation and set to the side.3) Insert refill unit completely into the warmer until you hear a click.4) Re-attach base to the warmer by lining up the edges and lightly pushing together.5) Plug the external power supply into outlet. A light will blink twice on the top of the warmer to indicate that it is ready to use.6) Place the warmer on a flat surface near the outlet standing upright. Placing warmer on its side or upside down will cause leakage.7) Adjust warmer to desired setting (off, low, med, high) using the slider on the back. The settings go from off (empty circle) to high intensity (3 filled in circles).8) Use warmer as it was received. Do not modify electrical plug.OPERATING INSTRUCTIONS1) Adjust warmer to desired setting (off, low, med, high) using the slider on the back. The settings go from off (empty circle) to high intensity (3 filled in circles). Switch to off when no scent is needed and switch to low, med, high for scent as needed.2) Press the "Boost" button any time you want to increase the scent. A blue light will turn on around the base of the warmer and remain on only during the boosting period (about 40 minutes). When the boosting period is over, the warmer will return to the scent intensity setting your originally chose. If you would like to turn the scent boost off before the boosting period is over, move the scent intensity slider on the back of the warmer to off (empty circle) and then move it back to your desired intensity setting (low, medium, high).3) A light will turn on and start blinking at the top of the warmer to indicate when it may be time to change your refill.For use with FEBREZE PLUG Scented Oil Refill.

Procter & Gamble